Boron nitride is a semiconductor material and has many applications in the electronics field.
The procedure for making evaporation boat is as follows:
– Get a glass slide and cover it with aluminum foil.
– Place the boron nitride on the aluminum foil and heat it up to about 450 degrees Celsius.
– Remove the heat from the boron nitride, and then let it cool down to room temperature.
– Take off the aluminum foil from the glass slide to reveal a boron nitride film, which can be used as an evaporation boat for evaporating solvents such as water or alcohol.
Boron Nitride evaporation boats is a type of evaporator that is used to form thin film.
Boron nitride evaporation boat has a high heat transfer coefficient, which facilitates the evaporation process. It also does not contain any metals and is environmentally friendly.
The boron nitride boat can be used for many different types of evaporations, such as semiconductor device fabrication and crystal growth.
The boron nitride thermal evaporation boat is a tool that is used to grow thin films of boron nitride.
The following steps are required to make a boron nitride evaporation boat:
1. Obtain a glass or metal tube with a diameter of 2-5 mm and an inner height of 10 mm.
2. Cut the tube into two pieces, making sure that one piece has an opening at the bottom and a length of 20-30 mm.
3. Clean the inside of the tube with acetone or alcohol and let it dry completely before proceeding to step 4.
4. Coat one piece with metal (e.g., aluminum) by dipping it in molten metal and letting it cool for about 1 minute before dipping again in molten metal and repeating the process until there are no longer any bubbles on the surface of the metal coating (about 5 minutes).We can make ceramic evaporation boat according to your requirement.
Leave a Reply